[1]

　　The following applies to the limiting values:

　　a) This product includes circuitry specifically designed for the protection of its internal devices from the damaging effects of excessive

　　static charge. Nonetheless, it is suggested that conventional precautions be taken to avoid applying greater than the rated

　　maximum.

　　b) Parameters are valid over operating temperature range unless otherwise specified. All voltages are with respect to VSSunless

　　otherwise noted.

　　c) The limiting values are stress ratings only. Operating the part at these values is not recommended and proper operation is not

　　guaranteed. The conditions for functional operation are specified in Table 9.

　　[2]

　　Maximum/minimum voltage above the maximum operating voltage (see Table 9) and below ground that can be applied for a short time

　　(< 10 ms) to a device without leading to irrecoverable failure. Failure includes the loss of reliability and shorter lifetime of the device.

　　[3]

　　Including voltage on outputs in tri-state mode. Does not apply to pin PIO0_6.

　　[4]

　　VDDpresent or not present. Compliant with the I2C-bus standard. 5.5 V can be applied to this pin when VDDis powered down.

　　[5]

　　VDDpresent or not present.

　　[6]

　　If the comparator is configured with the common mode input VIC= VDD, the other comparator input can be up to 0.2 V above or below

　　VDDwithout affecting the hysteresis range of the comparator function.

　　[7]

　　It is recommended to connect an overvoltage protection diode between the analog input pin and the voltage supply pin.

　　[8]

　　The maximum non-operating storage temperature is different than the temperature for required shelf life which should be determined

　　based on required shelf lifetime. Please refer to the JEDEC spec (J-STD-033B.1) for further details.

　　[9]

　　Human body model: equivalent to discharging a 100 pF capacitor through a 1.5 k

　　 series resistor.