Parameter conditions

　　Unless otherwise specified, all voltages are referred to VSS.

　　10.1.1

　　Minimum and maximum values

　　Unless otherwise specified the minimum and maximum values are guaranteed in the worst

　　conditions of ambient temperature, supply voltage and frequencies by tests in production on

　　100 % of the devices with an ambient temperature at TA= 25 °C and TA= TAmax(given by

　　the selected temperature range).

　　Data based on characterization results, design simulation and/or technology characteristics

　　are indicated in the table footnotes and are not tested in production. Based on

　　characterization, the minimum and maximum values refer to sample tests and represent the

　　mean value plus or minus three times the standard deviation (mean ± 3

　　Σ).

　　10.1.2

　　Typical values

　　Unless otherwise specified, typical data are based on TA= 25 °C, VDD= 5 V. They are given

　　only as design guidelines and are not tested.

　　Typical ADC accuracy values are determined by characterization of a batch of samples from

　　a standard diffusion lot over the full temperature range, where 95% of the devices have an

　　error less than or equal to the value indicated (mean ± 2

　　Σ).

　　10.1.3

　　Typical curves

　　Unless otherwise specified, all typical curves are given only as design guidelines and are

　　not tested.

　　10.1.4

　　Typical current consumption

　　For typical current consumption measurements, VDD, VDDIOand VDDAare connected

　　together in the configuration shown in Figure 9.