成都鑫业达自动化成套设备有限公司正品  现货供应    欢迎来电咨询   

　　For Sensor Relay Connector

　　Ratings and Specifications

　　*The operating temperature range is restricted by the maximum operating temperature of the cable.

　　Wiring Procedure

　　Wire Preparation

　　Use the strip gauge on the

　　front panel and strip 7 to 8 mm

　　of the insulation. If you use

　　stranded wires, twist them

　　several times.

　　Connection Procedure

　　1. Press a flat-blade

　　screwdriver into the

　　operation hole until

　　the operation lever

　　locks into place.

　　2. Insert the wire all the way into the wire insertion hole. Confirm that

　　the insulation on the wire also enters the wire insertion hole and

　　that the end of the wire has passed through the connection

　　section.

　　3. Insert a flat-blade screwdriver

　　into the release hole and

　　gently reset the lever. You

　　should hear the operation

　　lever reset.

　　4. Finally, check the following items.

　　• Make sure the operation lever has been

　　reset.

　　• Check the items given in step 2 again.

　　(Pull lightly on the wire to see if it is held

　　firmly in place.)

　　Disconnection Procedure

　　1. Press in the operation level, confirm

　　that the operation lever is locked into

　　place, and then pull out the wire.

　　2. After you remove the wire, always

　　reset the operation lever. However, if

　　you are going to connect another wire

　　to the same terminal, you do not need

　　to reset the operation lever and can

　　immediately connect the other wire.

　　Appearance Number of poles Model

　　成都鑫业达自动化成套设备有限公司正品  现货供应    欢迎来电咨询   

　　4 XN2A-1470