OANZ Listed

　　这个认证包含热塑性（PVC和PE）绝缘胶带，额定温度为80C ，做为电导体转接头唯一绝缘和覆盖保护，这个认证同样可以包含橡胶绝缘胶带，作为电导体转接头唯一绝缘或覆盖保护

　　The devices covered under this category are incomplete in certain constructional features or restricted in performance capabilities and are intended for use as components of complete equipment submitted for investigation rather than for direct separate installation in the field. THE FINAL ACCEPTANCE OF THE COMPONENT IS DEPENDENT UPON ITS INSTALLATION AND USE IN COMPLETE EQUIPMENT SUBMITTED TO UL.

　　USE

　　This category covers painting equipment, air compressors, vacuum pumps and components intended to be used with or within Listed products of other categories.

　　REBUILT PRODUCTS

　　This category also covers painting equipment, air compressors and vacuum pumps that are rebuilt by the original manufacturer. Rebuilt painting equipment, air compressors and vacuum pumps are factory rebuilt to the extent necessary by disassembly and reassembly using new or reconditioned component parts. Rebuilt painting equipment, air compressors and vacuum pumps are subject to the same requirements as new painting equipment, air compressors and vacuum pumps.

　　UL's Rebuilt Products Program for this category does not allow for the rebuilding or refurbishing or pressure vessels.

　　CONDITIONS OF ACCEPTABILITY

　　Unless specified otherwise in the individual Recognitions, consideration is to be given to the following Conditions of Acceptability when these components are employed in the end-use equipment:

　　1. These components may have been investigated for systems under pressure. The hydrostatic test pressure rating is the maximum hydrostatic pressure at which these products were tested. The maximum system pressure/vacuum rating is denoted as "Pressure Rating," and is in terms of pounds per square in (psi) for compressors, and inches mercury (Hg) for vacuum pumps.

　　2. Special consideration should be given to polymeric materials when a product is investigated for a specific application. The Materials Rating should be suitable for the application as outlined in the end-product standard or specifications. The Materials Ratings are designated "MR":