介绍高温钢体滑触线的七大特点及其安装方式:
Introduction of the seven characteristics of high temperature steel body sliding contact line and its installation method:
1、布线可多样化，可在上部，下部或侧面滑触。
1, the wiring can be diversified, in upper part, lower part or side sliding contact.
2、采用电阻率较小的铜导体或铜铝型材，可大幅度降低导线本身电能的损耗。
2, using smaller resistivity of copper conductors or copper aluminum, can greatly reduce the wastage of the electricity wire itself.
3、接触性能好，无拉弧现象，不会发生电源中断故障，运行可靠。
3, contact performance is good, no pull arc phenomenon, not happen power outage, reliable operation.
4、铜导体载流量大，最大可达3000A以上。
4, copper conductors carrying capacity, the maximum can reach more than 3000 a.
5、可适用于高温、高湿、高电压、强腐蚀、多粉尘等恶劣环境中。
5, can be applied to high temperature, high humidity, high voltage, strong corrosion, dust, etc. In the bad environment.
6、附加辅助电缆后，导线的阻抗能成倍降低，可组成低阻抗滑导线，应用更为广泛。
After six, additional auxiliary cable, the impedance of the conductor can be decreased exponentially, shall constitute a low impedance slide wire, applies more widely.
7、机械强度高、刚度好、不易弯曲变型，能承受较大的短路冲击电流，不致发生故障。
7, high mechanical strength, good rigidity, not easy to bend variant, can bear large short-circuit current impulse, not down.
滑触线的安装方式:一般采用上部滑触和侧面滑触２种安装刚体滑线:首先将绝缘子组件上的压板螺丝松开，把刚体滑线放在刚体坐子上。
Sliding contact line installation method: generally USES the upper sliding contact and lateral sliding contact 2 kinds of rigid sliding line installation: component will first insulator clamp screw loosening, rigid sliding on the rigid body sat the child.
再拧紧压板螺丝，刚体滑线连处应放置于支架与支架的中间钢体滑触线绝缘支架安装间距一般为3m 钢体滑触线一般情况下按6m定尺长度供货。
To tighten the clamp screw, rigid body slide wire even place should be placed in the middle of the stents with steel body sliding contact line insulation stent installing steel body sliding contact line spacing is commonly 3 m generally offered by 6 m specified length.
钢体滑触线绝缘支架安装间距一般为3m,滑触线分为单线式和双线平等馈电式两种。
Steel body sliding contact line insulation bracket installation spacing is commonly 3 m, equal sliding contact line is divided into single and double feed type two kinds.