安装加气混凝土墙板可不是件容易事，安装的时候要准确对线就位，可是加气混凝土墙板如何对线就位呢？

　　It is not easy to install aerated concrete wall panels. When installing, it is necessary to locate the line accurately, but how can the aerated concrete wall plate be placed on the line?

　　由于加气混凝土墙板对线就位为粗调校，加上木楔紧固时倘有微小错位，一般需重新调校即微调，板下端可通过锤打木楔使之调整在允许偏差范围以内。调校加气混凝土墙板时一人手拿靠尺紧靠墙板面测垂直度、平整度，另一手拿铁锤击打木楔。调整墙板顶部不平处:一人拿靠尺，另一人拿木方靠在墙板上，用铁锤在木方上轻轻敲打校正（严禁用铁锤直接击打墙板）重复检查平整度、垂直度，直至达到要求为止（检查垂直度时铝合金靠尺上吊挂线锤），校正后用铁板将挤出的胶浆刮平补齐，然后安装下一墙板，直至整幅墙板装完毕。

　　The aerated concrete wall on the line in place for coarse adjustment, if there is a small dislocation plus wedge fastening, generally need to re adjust the trimmer plate lower end by hammering wedge to adjust in the allowable deviation range. Adjustable aerated concrete wall a hand by foot close to the wall surface measuring verticality, flatness, the other hand a hammer hitting wedge. The adjustment of the top of the wall plate uneven: take one ruler, another person to take the wood on the wall, with a hammer in wood on tap (no correction directly with hammer hit the wall) double check flatness and verticality, until it reaches requirement (check the verticality of Aluminum Alloy hanging ruler line hammer) and the correction for the extruded mortar scraping plate filled, and then install a wall, the wall until the installation is complete.

　　一般安装下一块墙板时，对上一块或前几块墙板都有一定错位，加气混凝土墙板对线就位通常都是在整幅墙板安装完毕后，必须重新检查，消除偏差后方可填充细石砼或进行下道工序。

　　Generally, when installing the next wall panel, there must be some misplacement on the upper or the first few wall panels. The aerated concrete wall line is usually placed on the line after the installation of the whole wall panel. After that, it must be re examined. After eliminating the deviation, we can fill the fine concrete or carry out the next process.

　　山东非凡新型建材有限公司

　　诺商基于多年的优化经验和品牌基础推出的诺商商道系统，诺商信息您身边的互联网专家！