压瓦机使用前，要检查各处连接是否牢靠，安装螺栓、螺母是否拧紧，左右机箱内应加足润滑机油，才能通电启动机器进行试车，先空车运转仔细观察，有无震动，噪音，油窗口是否来油，各部件运动是否协调，一切正常后才能安装模具，安装模具时，必须切断电源，用手工搬动电动机皮带或大齿轮，使工作台转位，并使滑座上升到最高点，最好用一物件支撑在工作台及滑座底面之间，以防滑座自然下落，造成事故。

　　Pressure tile machine before using, to check whether everywhere connection rocky, installing bolts, nuts are tight, or so should add the lubricating oil box, can electrify start machine commissioning, first empty car running watch carefully, and presence of vibration, the noise, the oil window to whether the oil, and all the parts movement is harmonious, everything is normal to install mould, installation mould, must cut off power supply, with manual lift motor belts or big gear, make workbench inversion, and make slider up to the highest level, it is a thing on the support and slide the underside between, to prevent slippery a natural whereabouts, cause an accident.

　　机械设备的哪些部分应安装防护装置和安全装置

　　What part of mechanical equipment should be installed protection device and the safety device

　　1、人容易触及到的带电部位，如导线、电机、控制开关等。

　　1, people easy to touch by charged parts, such as wire, motor, control switch, etc.

　　2、由于湿度、有水飞溅、环境、刺激性气体或有毒气体等容易产生触电或其他危险的部位，如控制开关、导线等。

　　2, because the humidity, water splash, environment, stimulating gas or poisonous gas, easy to produce electric shock or other dangerous areas, like the control switch, wires, etc.

　　3、容易触及的传动设备，如皮带、齿轮、链、连轴器、离合器等。

　　3, easy to touch the transmission equipment, such as leather belt, gear, chain, even the shaft device, clutch, etc.

　　4、有发出噪音的部位。

　　4, a part of the noise.

　　5、产生高温的设备，人容易触及到的和其他物品触及到高温时影响其功能或会导致事故的部位。

　　5, produce high temperature equipment, people easy touches and other items to touch to affect the function or high temperature will result in the parts of the accident.

　　6、机械加工时容易导致被加工件或切削屑飞溅容易触伤人或破坏环境的部位。

　　6, mechanical process easy to cause the special or cutting flocks splash easy to hurt or touch the destruction of the environment parts.

　　Contact: ZhangBin

　　欢迎联系洽谈

　　Welcome to contact us and transact