7.2V-12V NiMh/Nicd battery pack charger with MCU intelligent control

　　Features

　　Charger for chargingNiMH /NiCdbattery packs-7.2V, 8.4V, 9.6V and 12V(6-10 cell pack) used in high-end airsoft guns, RC cars and airplanes

　　Fast charging with current switch to either 0.9A or 1.8A. Full charging takes 1 - 2 hours

　　Charging Current 0.9A for battery packs with capacity from 900mAh -1800mAh

　　Charging Current 1.8A for battery packs with capacity above 2000mAh. For 3000mAh pack, charging time is 1.5 hours

　　Smart automatic voltage detection

　　Pulse and negative pulse technology to avoid battery overheating during fast charging, optimized for battery pack life

　　Red LED is on during charging

　　Automatic charging ends with negative delta V

　　4 hour safety timer: Charging will stop after 4 hours of operation

　　Worldwide usage with 120-240V AC

　　Safety protection fuse for over current, short circuit & reverse polarity protection

　　Operation Instruction

　　Connect battery pack to output connector and plug AC power source

　　Make sure battery polarity is connected correctly (Red wire is positive)

　　Charger will detect battery voltage automatically. Red LED is on during charging

　　When battery is fully charged, current will reduce to trickle charging at 50mA and green LED will be on

　　Battery will be charged at 0.9A or 1.8A constant current

　　Approximate charging time is about 1.5 hours for 3000mAh battery,1hour for 1800mAh battery

　　Charger is designed for faster charging NiCd and NiMH battery packs from 6 to 12V for RC car/Air and Air soft gun

　　NEVER charge battery packs with voltage less than 6V or voltage greater than 12V and the capacity smaller than 1100mAh

　　Batterypack must be made by high drain current cell

　　Product Specification

　　For 7.2V-12V NI-MH/NI-CD battery pack 6-10pcs

　　Input: AC100-240V

　　Output: 7.2-12V, 0.9 or 1.8A

　　Accessories Included

　　1 standard Tamiya connector with the smart charger

　　1 connector adapter from standard Tamiya to Mini Tamiya

　　1 set of alligator clip adapter with standard Tamiya connector on one end

　　WARNING!

　　The charger is designed for indoor use only and it is NOT for charging any LI-PO battery

　　Never leave the charger unattended during charging

　　The charger should be laid horizontally and work in a well ventilated condition

　　Avoid water and keep away from flammable and explosive goods

　　Do not cover the charger when charging. Ambient temperature shall not be more than 40oC(104 degrees Fahrenheit)

　　Don't touch the plug. Keep away from children

　　Do not leave the battery and charger on wood surface or carpet while charging

　　Turn off power supply before connecting or disconnecting the charger to battery packs

　　Never disassemble the charger

　　Contact seller for questions. Both manufacturer and seller are not responsible for any damage and consequent damage caused by misuse of this product

　　Dimension

　　Outline dimension:120L X 60W X 38(H) mm MAX;