（PT）硅胶油墨

　　承印物:硅胶,橡胶,硅橡胶,LDPE等材质产品举例:硅橡胶电缆,医用导管,笔套,按键,手环二、产品特性: 1、色彩鲜艳,高弹性,高浓度,低气味,耐酒精,耐磨,遮蔽性优秀,附着力优秀 2、适用于丝印和移印工艺 3、产品细度:5um以下三使用说明: 1、丝印网板:150—450目聚脂丝网印版胶刮:建议使用65-85度聚氨酯胶刮用量:400目网板印刷约为45㎡/kg 200℃以下烘干,约30分钟 2、移印溶剂: 718快干水,783慢干水,因印刷环境温度不同进行选择清洗: 选用有机溶剂清洗（如:718,783）用量:约为45㎡/㎏四、注意事项: 以上是以我司的测试结果,谨供参考。量产前务必在贵司的条件下,再次测试为盼。五、产品包装: 1公斤装、5公斤装、20公斤装六、储存条件: 5℃—25℃条件下可存放两年,避免强光照射,防接触强酸,强碱。

　　(PT) silica gel ink

　　,

　　A2: silicon rubber, things, silicone rubber mold LDPE, the material such as product example: silicone rubber cable, medical catheter, pen, key, hand ring the product characteristics: 1, colourful, high elastic, low resistance, high concentration, smell alcohol, wear-resisting, excellent adhesion, good cover sex 2, and is suitable for printing and pad printing process 3, product fineness: 5 um three instructions: 1, silk screen: 150-450 mesh polyester silk screen printing plate rubber blow: suggest using 65 85 degrees, pu adhesives scraping the dosage: 400 mesh screen printing of about 45 ℃ below 200 ㎡ / kg dry, about 30 minutes 2, pad printing solvent: 718, 783 fast drying water water, for printing slow dry environment temperature choose different cleaning: choose organic solvents washing (such as: 718783) usage: about 45 ㎡ / ㎏ four, the points for attention: the above is our test results, only for reference. Be sure to be in your company quantity antenatal under the conditions of the test for hope again. Five, the packing of products: 1 kg outfit, 5 KGS, 20 KGS six, storage conditions: 5 ℃-25 ℃ conditions can deposit two years, avoid glare, the strong acid, strong alkali contact.