1、速冻冷库绝热工作:

　　1, frozen cold storage insulation work:

　　Insulation work according to the design requirements of the material, the construction together with the insulation casing wear well, leaving the welding mouth, the final treatment of the welding port. When the construction is strictly prohibited insulation layer off phenomenon, insulation casing lap must be tied with tape.

　　2、速冻冷库库板保养，注意使用中应注意硬物对库体的碰撞和刮划。因为可以造成保鲜冷库板的凹陷和锈蚀，严重的会使库体局部保温性能降低。

　　2, frozen cold storage warehouse maintenance, attention should be paid attention to the use of the hard object on the base of the collision and scraping. Because it can cause the depression and corrosion of the plate, the local thermal insulation performance of the reservoir will be reduced.

　　3、速冻冷库制冷机组上的冷凝器很容易被沾污，应根据实际情况定期清洗。以保持良好的传热效果。散热好，制冷才好。制冷机组周围不要堆放杂物；

　　The condenser 3, frozen cold storage refrigeration unit is easy to be contaminated and should be cleaned regularly according to the actual situation. In order to maintain a good heat transfer effect. Good cooling, cooling is good. Do not pile up around the cooling unit;

　　4、速冻冷库地面保养，一般小型速冻冷库的地面使用保温板，使用速冻冷库时应防止地面存有大量的冰和水，如果有冰，清理时切不可使用硬物敲打，损坏地面。

　　4, frozen cold storage floor maintenance, general small quick freezer ground use insulation board, use frozen cold storage should be to prevent the ground being large quantities of ice and water. If there are ice, clean cut do not use rigid thing.no, damage to the ground.

　　5、速冻冷库设备的库内温度、温差等参数，这些都应根据速冻冷库安装技术要点而定，不可任意改变参数。冷库出厂时已根据用户要求而定制，要了解速冻冷库的技术参数后再进行控制器上各项参数的设定。

　　5, frozen storage equipment, storage temperature, temperature and other parameters, which should be based on the technical points of frozen cold storage installation, can not be arbitrarily changed parameters. Cold storage factory has been customized according to customer requirements, to understand the technical parameters of frozen cold storage, and then set the parameters of the controller.