详细说明
'
韩晶电子有限公司创办于1998年,是一家专业生产各类轻触开关、按健开关,拔动开关,DC插座,耳机插座,USB插座的电子企业。产品广泛应用于家用电器、数码相机、玩具、汽车音响、电脑及IT周边产品等产业领域。
�1�70�1�75�1�71�1�70 style="TEXT-ALIGN: left" align=left>
This specification covers the USB CONNECTOR DIP OR SOLDER TYPE
[本规范适用于USB CONNECTOR DIP OR SOLDER TYPE ]
2.[产品料号及产品名称] PRODUCT NUMBER AND PART NAME
[产品品名] Product Name | [产品料号] Product Number |
| |
| |
3.[构造&组成零件] CONSTRUCTION & COMPONENTS
[依照工程图] Based on construction drawing
4.[标准额定值] RATINGS
[项目] Item | [规格] Standard |
[额定电压] Rated voltage | 30V AC rms Max. |
[额定电流] Rated current | 1.5A Min |
[使用温湿度环境] Operating temperature | -30℃~+85℃, 85% RH Max |
[储存温湿度环境] Storage temperature | -40℃~+60℃, 85% RH Max |
5. [试验条件] TEST CONDITION
[除非特别说明之外,一般试验及测理将于温度15~35℃,相对湿度25~85%,大气压力86~
106kPa之条件下完成,但若于上述条件下有任何影响判定值的疑虑,可考量在温度20±2℃,相
对湿度60~70%,大气压力86~106kPa之条件下完成试验
The test and measurement,unless otherwise specified,shall be carry out at atemperature of 15 to 35℃,Relative humidity of 25 to 85%,and atmospheric of 86 to 106kPa.However,when any doubt arises on the judgment value it,the test and measurement
shall be carry out at a temperature of 20±2℃,relative humidity of 60 to 70%,and atmospheric pressure of 86 to 106Pa.
[外观:经目视观察,外观不可有变形,电镀脱落等会降低其功能的异常现象,也不可有严重破裂,刮伤或污损之缺点.Appearance:By looking,there shall not be any abnormality such as deformity,exfoliation of plating,ETC,which can reduce performance,No defect such as cracks scratchs or blemishes. |
6.[电气特性] ELECTRICAL EFFICIENCY
编号NO. | 项目/Item | 试验方法/Test Method | 性能要求/Requirement |
6.1 | [额定电流]ContactCurrent Rating | [于室温25℃下施加250V AC电压测试]Measured at an ambient temperature of 25℃,applied 250VAC test. | 1.5A Min. |
6.2 | AppliedVoltage Rating[额定电压] | 30V AC(RMS.) continuous maximum,on any signal pin withrespect to the shield.[在任一端子与端子,端子与外壳间施加最大电压30V AC测试] | No Breakdown无击穿 |
6.3 | ContactResistance[接触阻抗] | Mate connectors,Measure by dry circuit,20mV Max,100mA[公母对插后测试] | 30mΩMax |
6.4 | [绝缘阻抗]InsulationResistance | [公母不对插,对相邻端子施加500V DC电压测试]Unmated connectors, apply 500V DC between adjacentterminal or ground. | 1000MΩMin |
编号NO. | 项目/Item | 试验方法/Test Method | 性能要求/Requirement |
6.5 | [耐电压]WithstandingVoltage |
'