Features:

　　1.All materials are UL 94VO grade,high temperature resistance plastic

　　2.Twin contact design to ensure stable contact.

　　3.Gold-plated contact to ensure low contact resistance.Tin plated terminals to prevent contamination during soldering.

　　Ratings:

　　Contact Rating

　　Switching         :25mA at 24VDC

　　Non-Switching     :100mA at 50VDC

　　Contact Resistance

　　Initial             : 50MΩMax

　　After life          :100MΩMax

　　Insulation Resistance:100MΩMin,60sec at 500VDC

　　Dielectric Strength:500VDC for 60 seconds

　　Switch Capacitance:5pF Max at 1 MHZ

　　Operation Temperature:-40℃~+85℃

　　Storage Temperature:-40℃~+85℃

　　Mechanical&Processing

　　Operation Force:1000gfMax

　　Mechanical Life :3000 cycles Operations

　　Switch Operation and Taping

　　1.Use Tweezer or ball point pen for operation

　　2.Flux cleaning should be done without removing the Tape.

　　3.If the Tape is removed,it adhered less than before when it is placed back on ,possibl causing flux inflow.

　　4.Do Not Remove Tape sealed before Reflow Processing.

　　5.Ultasonic cleaning not recommended without Tape sealesd

　　*Keep all actuators in “OFF”position during soldering and cleaning process.

　　*Any flux enters the switch may influence contact function.

　　Environmental TEST

　　Cold Resistance Test

　　Switches under temperature at - 40℃ ±2℃ for 96 hours

　　Dry Heat Resistance Test

　　Switches under temperature at 85℃ ±2℃for 96 hours.

　　Humidity Test

　　Per MIL-STD- 202F,Method 103B Test Condition B:

　　There shall be no evidence of corrosion and the insulation resistance shall be no less than 100   megaohms

　　Vibration Test:

　　Per MI-STD- 202F,Method204 D，Test Condition A:

　　There shall be no opening of closed contacts or closing of open contacts in excess of 10  microseconds.

　　Shock Test:

　　Per MIL-STD- 202F,Method 213B ,Test Condition A:

　　There shall be no opening of closed contacts or closing of open contacts in excess of 10 microsecond.

　　Thermal Shock Test:

　　Per MIL-STD- 202F,Method 107G，Test Condition A:

　　There shall be no evidence of physical damage or permanent change in electrical characteristics .

　　Salt-Spray Test

　　Per MIL -STD - 202 F,Method 101D,Test Condition B :

　　There are under 35℃ ±2℃  in temperature and 5±1% salt-water concentration for 48±1   hour.